![]() You'll definitely need to experiment to find a good setting, since it's more than just a single "faster/slower" knob. These options are more fully documented in the man pages (run man nf and search for the "POINTER ACCELERATION" section, or try reading this online copy). If no amount of tweaking seems to let you both move the pointer quickly across the whole screen and move it slowly in a small area, you should try reseting both properties to 1.0 and then changing the acceleration profile. If you loose the ability to position the cursor precisely with slow movements afterwards, try increasing the "Adaptive Deceleration". At some point this should cause the cursor to move fast enough. If necessary, you can make it less than 1. To speed up your pointer, first try decreasing the "Constant Deceleration" value. (For the curious: it should be set to 1000.0/ExpectedRate where ExpectedRate is the rate in Hz at which the input device sends events the Intuos tablets send touch events at ~100Hz). You'll may notice a "Device Accel Velocity Scaling" property in the output as well - this knob doesn't do what you might think and should generally be left alone. You can see the current values of these and other device properties by running xinput list-props. ![]() $ xinput set-float-prop "Device Accel Adaptive Deceleration" $ xinput set-float-prop "Device Accel Constant Deceleration" There are three pointer acceleration options of interest that can be adjusted at runtime with the xinput utility: $ xinput set-int-prop "Device Accel Profile" 8 The Wacom driver stopped providing its own (redundant/crude) acceleration options all the way back in late 2009. You need to adjust the X server's pointer acceleration options for the device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |